If your dimmer doesn't have terminal wires, place a hook at the end of the stripped wire, wrap around the screw, and then tighten the screw. Many new dimmers no longer have terminal wires and use screw terminals that might be similar to the ones on the switch you removed instead. If the wires are flattened, nicked, or damaged, clip off this portion of the wire and strip a 3/4-inch fresh section. Straighten out any loops in the copper wires, using needle-nose pliers. ELEGRP Digital Dimmer Light Switch for 300W Dimmable LED/CFL Lights and 600W Incandescent/Halogen, Single Pole/3-Way LED Slide Dimmer Light Switch, Wall Plate Included, UL Listed, 6 Pack, Matte White. Comes with white faceplate installed, optional ivory and light almond faceplate included. Single pole or 3-way control when used with 3-way switch. The new dimmer switch will be connected to the circuit wires using wire nuts or another form of wire connector, so the circuit wires may need to be straightened. 600-Watt to 120-Volt AC incandescent and 150-Watt to 120-Volt AC dimmable LED and CFL, 60Hz. If your switch is attached via push-in fittings on the back, you can remove them by pushing a small nail into the release slot next to each push-in screw terminal, or simply clip them off with your wire cutters and re-strip them to the proper length. You can even mix bulb types such as LED + halogen on the same circuit. LEVITON SLIDER LED DIMMER SWITCH - WHITE Universal decora dimmable LED,CFL and incandescent IllumaTech slide dimmer 60Hz Single pole 3-way 600 watt. Great prices & free shipping on orders over 50 when you sign in or sign. This dimmer works with up to 150-Watt of dimmable LED or 600-Watt of incandescent/halogen. Order Leviton DIMMER SWITCH 3W ARCH SLIDE DIMMER 26666-31I, 26666-31I at. If that's the case, simply unscrew them and untwist the wires. The Contour LED+ slide dimmer switch provides optimal dimming performance of LED bulbs. Turn your house into a Smart Home The Smart Slide Dimmer is a hardwired dimmer switch that turns your phone into a remote control. Alternatively, your old switch might be connected with wire nuts. If a ground wire is also attached, disconnect it from the green ground screw. The Spruce Home Improvement Review BoardÄetach the circuit wires by loosening the screw terminals on the side of the switch and pulling the wires free. 23.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |